Door-trim Removal

 

Open the window and remove the little cap on top of the pillar  (blue circle)

 

Remove the screw that will be accessible after the removal of the cap
(use a magnetic screwdriver...otherwise the screw will drop)

 

 

Gently pull off the cover on the inside of the door.
the bottom of the cover is attached with a little clip that will pop off (red circles)

 

(Driver-side only)
Remove the screw on the inside of the door-handle
(Passenger-side only)
Remove the caps on the door-handle (see red circles)
and remove the 2 screws that will become visible
Remove the 2 screws that hold the trim on the (in)side of the door 
Remove the screw on the other side of the door
(Driver-side)
Gently pull out the plastic part with the switch and door-handle
(Passenger-side)
Gently pull out the plastic part with the window-switch
Disconnect the connector from the switch
Gently pull out the plastic that surrounds the door-opener
Now pull the bottom part of the door-trim (1)
It's attached with small plastic clips (yellow circle) that should pop out.
Once the bottom part is loose, move the trim upwards (2) and it will come off
Done !

this write-up was taken and translated from the Japanese Falcon Z-website